Amada's Quick Change Single "V" Dies dramatically reduce set-up time on the press brake machine.
This saving relies upon the setting of the die holder onto the bottom main beam only once.  Once this is set, the individual single "V" dies can be then located into position.

When an exchange of die is required, the die is changed quickly by simply lifting out the used die and dropping the new die into position within the die holder.  The time consuming exercise of fixing bolts to the holder is eliminated thus decreasing the set-up time and increasing productivity.

The advantage of using single "V" tooling is that it enables the user to form components, where otherwise not possible due to the complex cross-section of the component.

All 1V dies are made from high quality steel composed specifically for bending purposes with superior tensile strength (1100 to 1200 N/mm²) and best load-bearing capacity. A high degree of accurate process repeatability is given even for difficult coining operations.

Our highly wear resistant AMANIT^®    quality (up to 65 HRC surface hardness) is standard on every die and available directly from stock.